after the switchover in December 09 I retuned the 37 inch plasma Panasonic and all seemed to work OK.
but after the screen detecting new channels in Jan I chose to rescan ..... that was a mistake.
It messed up the channels , and gave me S4C and poor quality Channel4
looking at the signal strength and frequency of each, I could see that I was receiving from 2 transmitters.
no matter how much I tried I couldnt adjust them!
In the end the heath robinson solution was to scan and take a note of the position on the horizontal bar where the Welsh data was transmitted on (lower value) and where the higher band winter hill signal started.
I used my them but you could use tape lol
I then removed the aerial , rescanned and waited until I had got past the freq the Welsh channels would have been on (if the aerial was connected)
then quickly shoved the aerial back in...
voila full strength all channels , all in correct order, all from winter hill.
RESULT
No comments:
Post a Comment